Axle Clips - Used to strap bed caps to axles and for shaft couplers. 5/16 inch with square nut. Availalbe in 1/2 inch increments from 2 to 7 inches. Measure between threads. State size.       $2.20 each Perch clips (one thread longer) 4 or 4-1/2 inch       $2.20 each Spring clips - 1/2 inch round steel, 10 1/2" or 11" overall length       $2.30 each Axle Clip Bars - Available in 1, 1-1/8, 1-1/4 and 1-1/2 inches between holes.       $.85 each Axle Washers - Old style leather coil for Sarven wheels       $3.95 Carriage Brakes - Hydraulic brake systems. Kits sold complete with hub shoes, hoses, assembly pedal, master cylinder, lines, and brake fluid. Bolt holes are not bore out on 8 inch brakes. Specify axle size when ordering. 8 inch for 1, 1-1/8 or 1-1/4 inch axle       $229.95 10 inch for 1-1/4 or 1-1/2 inch axle       $279.00 12 inch for 2 inch axle       $399.00 Cart Seat Bracket - Iron bracket to allow for Meadowbrook seat to fold.       $29.90 pair Eagle Heads - Replacements for dash of Portland cutter. 3-1/3 inches long       $16.50 pair End Gate Latch - Flat spring latch for spring wagons       $6.95 each End Gate Fastener - Hook and bracket set       $10.25 set Hub Caps - Fits bolt hubs Chrome       $15.00 each Brass       $13.00 each Steel       $2.50 each Double Tree Clevis - Attaches double trees to evener on buggy       $10.95 each Double Tree Clevis Draft Style - 3, 4, or 5 inch openings Specify 3, 4, or 5 inch opening       $6.96 Neck Yoke Ring Draft - Fits on center of neck yoke       $8.10 Neck Yoke Ends Draft       $7.99 each Neck Yoke Leather Center - Buggy style       $12.25 Tongue End Draft Style       $11.95 Rein Holder - Fits over edge of dash where there is no rein rail. Solid brass       $16.95 Rein Rails - Fancy ends, smooth on outside so lines cannot get caught. Specify length between bolts Brass       $59.95 Chrome       $89.95 Center post with bolt       $13.90 Roller Irons - Mounts on bottom of buggy so when turning wheel does not turn under box. Iron with 5/8 inch roller and stainless pins.       $7.25 each Spring Block - Mounts crosswise on axle and supports spring. Cast iron for 1-1/2 inch spring and 1" or 1-1/8 inch axle. Indicate axle size.       $10.95 each Wood Spring Block - Specify axle width       $6.95 Spring Seat Hanger - Zinc alloy       $3.95 each Top Prop with Bell       $4.25 each Top Nuts Shiney black       $3.75 Primed       $2.50 Brass       $5.25 Chrome       $7.95   This catalog page was last updated at 11:01 am on August 25, 2008.